You asked: How do I reset the tension on my sewing machine?

Why is my thread looping underneath?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. … In this case, it might be necessary to loosen both the bobbin tension AND the top tension.

What number should the tension be on a sewing machine?

Most sewing projects will have the tension dial set to 4.

How do I reset the bobbin tension?

To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.

Why is the tension wrong on my sewing machine?

Needles, threads, and fabrics: Different thread sizes and types on top and in the bobbin can throw off basic tension settings. A needle that’s too large or small for the thread can also unbalance your stitches, because the size of the hole adds to or reduces the total top tension.

Why is my sewing machine stitching loopy?

Looped stitches are usually caused by improper tension. If the loop is on the upper side, it may be corrected by loosening the top tension or by tightening the lower tension. … Looping of stitches is sometimes caused by placing the bobbin in the bobbin case the wrong way.

IT IS INTERESTING:  Why is cross stitch considered art?

How do you know thread tension is correct?

To test if the tension is correct, insert a bobbin in the bobbin case. Then hold it up by just the thread, the bobbin case shouldn’t move. Give a little jerk on the thread and if the bobbin case slides down slightly, then the tension if perfect. If it drops freely, then it’s too loose.

What tension should I use for cotton?

Cotton requires a moderate tension setting, usually between three and four.

Why is my bottom stitch loose?

Probable Causes: – Top or bobbin thread is not set correctly. – Make sure that the bobbin was threaded properly in the shuttle race. …

Why is my upper thread tight?

If the bobbin thread was incorrectly threaded, the upper thread may be too tight. … If the upper thread was incorrectly threaded, the upper thread may be too loose. 4. To increase the upper tension – increase the tension setting or turn the knob to the right.

How do you tighten thread tension?

Changing Bobbin Tension

You should see a small screw on the flat/closed side of the bobbin case. Turning the screw a tiny bit counterclockwise will loosen the bobbin tension; turning it clockwise will tighten the tension.